Preparation:

  1. Mesh & Squeegee: 120(48T) Mesh number; 65-75 degree Squeegee.
  2. Pigments added ratio: For white and fluorescent colors 20%, other colors 10%.
  3. Catalyst mixing ratio:10% slow dry XG-MB-1 Mid dry XG-ZB-1.
  4. Silicone thinner XG-128A adding ratio:0-20%.
  5. Heating Temp and time: cure temp: 60℃~100℃, dry by room temp.

Silicone ink printing tips:

1.Elastic silicone ink clear printing for 4-6 times:

Elastic Silicone XG-130A    50G   50%

Elastic Silicone XG-130B    50G   50%

Silicone thinner XG-128AH   10G    10%

Cure by 60℃~100℃, or by room temp. If need fast dry then can mix with catalyst XG-866B-2  1-2%

2.Color effect silicone printing for 3-4 times:

Elastic Silicone      XG-130A    50G   50%

Elastic Silicone      XG-130B    50G   50%

Silicone pigments   XG-501     10G    10%

Silicone thinner XG-128AH   10G    10%

Cure by 60℃~100℃, or by room temp. If need fast dry then can mix with catalyst XG-866B-2  1-2%.

3A.Matte silicone ink for top coating printing 1-2 times.

Matte silicone top coating for 2 times wet on wet printing:

Matte silicone ink   XG-136M-1     100G

Slow dry catalyst    XG-MB-1      10G   10%

Silicone thinner     XG-128AH     0-10G  0-10% Cure by 60℃~100℃, or by room temp.

3B:Glossy silicone ink for top coating 2 times:

Glossy silicone ink   XG-399-2     100G

Slow dry catalyst    XG-MB-1      10G   10%

Silicone thinner     XG-128AH     0-10G  0-10%

Glossy top coating for 2 times wet on wet printing, to get silicone bubbles out first, try to use cold wind to support and it will be better to use low temp by longer heating time to avoid bubbles problem.

Cure by 60℃~100℃, or by room temp. After printing, heat by 80℃ for about 2-3 minutes or do not heat, room temp to keep for over 24 hours.

Elastic silicone ink for excellent elastic band ribbon
Elastic silicone ink for excellent elastic band ribbon

Leave a Reply

您的电子邮箱地址不会被公开。 必填项已用*标注

我们将24小时内回复。
取消

Hi ,this is Belinda,May I have your name? Which type of silicone ink are you interested in?