How to print high density brush silicone stickers. 3D silicone brush transfer logo printing tips:

Matte PET films or Teflon paper:

Mesh number 120-200 , Mesh(screen film )thickness 0.1-0.2MM,it is depends on printing Artworks.

Squeegee:65-80 degree .

Printing tips:

1 Transfer hot melt glue XG-360R-2 or XG-360R-3 print for 8-10 times

When printing glue to use cyclohexanone to liquid the glue,mixing ratio 10%.This type of glue easy to be thick and mesh printing.

  Flash by room temp or by 100-120 degree.

2 Mid layer Transfer silicone crossing linker printing for 2 times:

Crossing linker      XG-360Z-3X     50G

  Catalyst             XG-866B-2+   2.5G   5%

Flash by 100 to120 degree.

3 Transfer silicone ink clear layer printing 4 -6 layers: 

  Silicone ink     XG-866A-2Y       100G

  Catalyst     XG-866B-2             3 G         3%

Thinner         XG-128AH          10-20G    10-20%

Hot melt glue with solvent chemicals so will get silicone ink not easy to dry ,if need fast dry then can mix with more catalyst.

Flash by 100 to120 degree.

For high density stickers,if need more high density then print more times clear.

4 Transfer silicone ink color print for 2-4 layers  :

Silicone ink     XG-866A-2Y       100G

Pigments or special powders       10-20G  (10-20% white&fluorescent 15-20% other colors 10%)

  Catalyst     XG-866B-2           3G   3%

Thinner         XG-128AH          10-20G    10-20%

5 Transfer silicone for brush print for about 20 layers.

Silicone ink            XG-866A-2Y        200G

Color pigments        XG-series          10-40G white and fluorescent color 20% others 10%

(If need color brush effect)

Fast dry catalyst        XG-866B-2        6G  3%  

Thinner            XG-128AH           40-60G  20-30%

Cure by temp of 120℃ 6-15 seconds.

Tips for silicone brush printing:

  1. After 3 times brush printing should add 10% more thinner and print by pulling printing
  2. Need more thinner liquid silicone ink full coating on the screen.
  3. Mixing more ink and make sure ink coat the screen when printing brush.
  4. Print very soft to get more ink drop though the mesh and pull up the screen to get high density.

6 After finish, put into the oven to bake by 100 degree for30 minutes .

7 Heat press the stick on the heat transfer press machine by the temp of 160-170 degree for 10-16 seconds with pressure of 4KG.

TIPS:Kindly doing test before the bulk goods printing every time.

If any questions kindly contact by Cell:+86 18319607489    wechat&whatsapp the same number.

XG silicone for 3D silicone stickers printing Heat transfer silione ink
XG silicone for 3D silicone stickers printing Heat transfer silione ink
XG silicone for 3D silicone stickers printing Heat transfer silione ink
XG silicone for 3D silicone stickers printing Heat transfer silione ink

Leave a Reply

Your email address will not be published. Required fields are marked *

我们将24小时内回复。
取消

Hi ,this is Belinda,May I have your name? Which type of silicone ink are you interested in?