Preparation:

  1. Mesh: 180-300(70T-120T) Mesh number ;
  2. Squeegee:70-75 degree Flat Squeegee
  3. Fixer mixing ratio: 9103 Fixer mixing ratio 1-2% (If under coating clear SND-110 to mix fixer SND-110B 10%)
  4. Reducer :0-20%
  5. Flash by air or heating by 40-60℃
  6. Cure by waiting over 12 hours or heat by 40-60℃ for 30 minutes

Solvent based ink printing process:

1.Under coating Clear SND-110AB print for 1 time:

Under Coating Solvent Based Clear     SND-110A         20 G

Under Coating Clear Fixer SND-110B 2G 10% Flash by air or heating by 40-60℃

2.Color Solvent Based Ink for 3-4 times

White Solvent Based Ink      SND-102           40 G

Solvent Based Fixer         SND-9103         0.4- 0.8G   1- 2%

Solvent Based reducer 4-8G 10-20% Flash by air or heating by 40-60℃

After finishing printing to Cure by waiting over 12 hours or heat by 40-60℃ for 30 minutes.

Solvent Based Ink Printing Ink for water proof fabric
Solvent Based Ink Solvent Screen Printing Ink

Solvent-Based Screen Printing Ink and Fixer

Solvent-Based Ink and Fixer

Leave a Reply

Your email address will not be published.

  • *

    code