Preparation:

1.Mesh&Squeegee: 120(48T) Mesh number ;65-75 degree Squeegee

2.Pigments added ratio:For white and fluorescent color 20%,other color 10%

3.Catalyst mixing ratio:2% slow dry XG-866B-1 and fast dry XG-866B-2 can mix together for using

4.Thinner XG-128A adding ratio:0-20% thinner is not necessary for hand printing

Heating Temp and time: Flash cure temp :100– 120for 6-12 seconds ,Drying

temp :120– 140for about 2 -5 minutes

1.HD silicone for under coating and high density printing

HD silicone XG-866AH 100G. Fast dry catalyst XG-866B-2 2G 2%

HD clear to print for 2-6 times if need more high density then print more times

Heating temp 120-140degree

2.Color effect printing

HD silicone XG-866AH 100G. Fast dry catalyst XG-866B-2 2G 2%

Color pigment 10G 10-20% (white and fluorescent color 20% others 10%)

Color silicone to print 3-4 times

Flash temp 120-130degree

3.Glossy silicone for top coating printing

Glossy silicone XG-399HR 100G. Fast dry catalyst XG-866B-2 2G 2%

Glossy top coating to print 1-2 times ,if print glossy two times better to print wet on wet.

Flash temp 100-120 degree

Key point for glossy printing

1.The angel between squeegee & table 60-70 degree,if manual printing about 45 degree

2.Keep distance between printing squeegee & screen

3.Less pressure print very soft and slowly try to get more ink pass through the mesh to get round glossy effect.

Leave a Reply

您的电子邮箱地址不会被公开。 必填项已用*标注

我们将24小时内回复。
取消

Hi ,this is Kingjoe,May I have your name? Which type of silicone ink are you interested in?