Preparation:

  1. Mesh&Squeegee: 120(48T) Mesh number; 65-75 degree Squeegee.
  2. Pigments added ratio: For white and fluorescent color 20%,other color 10%
  3. Catalyst mixing ratio:10% slow dry XG-MB-1 Mid dry XG-ZB-1
  4. Silicone thinner XG-128A adding ratio:0-20%
  5. Heating Temp and time: cure temp :80℃,100℃,120℃ or dry by room temp.

Silicone ink printing tips:

Elastic silicone ink clear printing for 2-6 times :

Elastic Silicone XG-130A    50G   50%

Elastic Silicone XG-130B    50G   50%

Silicone thinner XG-128AH   10G    10%

Cure by 80℃,100℃,120℃ or dry by room temp If need fast dry then can mix with catalyst XG-866B-2 1-2%

Color effect silicone printing for 3-4 times:

Elastic Silicone      XG-130A    50G   50%

Elastic Silicone      XG-130B    50G   50%

Silicone pigments   XG-501     10G    10%

Silicone thinner XG-128AH   10G    10%

Cure by 80℃,100℃,120℃ or dry by room temp If need fast dry then can mix with catalyst XG-866B-2 1-2%.

Glossy silicone ink for top coating:

Glossy top coating for 2 times wet on wet printing:

Glossy silicone ink   XG-399-2     100G

Slow dry catalyst    XG-MB-1      10G   2%

Silicone thinner     XG-128AH     0-10G  0-10% Have to get silicone bubbles out first ,try to use code wind to support and it will be better to use low temp by longer heating time to avoid bubbles problem.

Cure by 80℃,100℃,120℃ or dry by room temp After printing finish, to heat by 100℃- 120℃ for about 2  minutes or room temp for over 24 hours.

XG Elastic silicone ink for Elastic ribbon printing
Elastic Silicone Silicone ink for elastic ribbon printing

Leave a Reply

Your email address will not be published.

  • *

    code

您好,有任何疑问请与我们联系!

Hi ,this is Belinda,May I have your name? Which type of silicone ink are you interested in?