Preparation:
1.Mesh&Squeegee: 120(48T) Mesh number ;65-75 degree Squeegee
2.Pigments added ratio:For white and fluorescent color 20%,other color 10%
3.Catalyst mixing ratio:2% slow dry XG-866B-1 and fast dry XG-866B-2 can mix together for using
4.Thinner XG-128A adding ratio:0-20% thinner is not necessary for hand printing
Heating Temp and time: Flash cure temp :100℃– 120℃ for 6-12 seconds ,Drying
temp :120℃– 140℃ for about 2 -5 minutes
1.HD silicone for under coating and high density printing
HD silicone XG-866AH 100G. Fast dry catalyst XG-866B-2 2G 2%
HD clear to print for 2-6 times if need more high density then print more times
Heating temp 120-140degree
2.Color effect printing
HD silicone XG-866AH 100G. Fast dry catalyst XG-866B-2 2G 2%
Color pigment 10G 10-20% (white and fluorescent color 20% others 10%)
Color silicone to print 3-4 times
Flash temp 120-130degree
3.Glossy silicone for top coating printing
Glossy silicone XG-399HR 100G. Fast dry catalyst XG-866B-2 2G 2%
Glossy top coating to print 1-2 times ,if print glossy two times better to print wet on wet.
Flash temp 100-120 degree
Key point for glossy printing
1.The angel between squeegee & table 60-70 degree,if manual printing about 45 degree
2.Keep distance between printing squeegee & screen
3.Less pressure print very soft and slowly try to get more ink pass through the mesh to get round glossy effect.
