Preparation:

1.Mesh&Squeegee: 120(48T) Mesh number ;65-75 degree Squeegee

2.Pigments added ratio:For white and fluorescent color 20%,other color 10%

3.Catalyst mixing ratio:2% slow dry XG-866B-1 and fast dry XG-866B-2 can mix together for using

4.Silicone thinner XG-128A adding ratio:0-20% Silicone thinner is not necessary for hand printing

5.Heating Temp and time: Flash cure temp :100℃- 120℃ for 6-10 seconds ,Drying temp :120℃- 140℃ for about 2 -3 minutes

Silicone ink printing tips

1.HD silicone 866AH for under coating and high density printing for 6-12 layers

HD silicone XG-866AH 100G. Silicone thinner XG-128AH 10G 10%.

Fast dry catalyst XG-866B-2 2G 2%

Cure by temp of 120℃ 6-10 seconds. If fabric with serious hairy or want to get more smooth effect kindly assist by heat press machine or iron after first time printing. After printing keep wet to heat press by temp 150-170 degree for 10-20 seconds

2.Round silicone mix with golden powder to print 3 layers

Round silicone XG-866A-2Y 100G. Golden powder 63306 10G 10%

Silicone thinner XG-128AH 20G 20%. Fast dry catalyst XG-866B-2 1G 2%

If machine printing to use slow dry catalyst. Cure by temp of 120℃ 6-10 seconds.

3.Glossy silicone ink for top coating

Glossy top coating for 1-2 times

Glossy silicone ink XG-399-3 100G. Fast dry catalyst XG-866B-2 2G 2%

Cure by temp of 100-110℃ 10-25 seconds Have to get silicone bubbles out first ,try to use code wind to support and it will be better to use low temp by longer heating time. To avoid bubbles problem. After printing finish, to heat by 120℃- 140℃ for about 2 -3 minutes.

Leave a Reply

您的电子邮箱地址不会被公开。 必填项已用*标注

我们将24小时内回复。
取消

Hi ,this is Kingjoe,May I have your name? Which type of silicone ink are you interested in?