Preparation

1.Mesh&Squeegee: 120(48T) Mesh number ;65-75 degree Squeegee.

2.Pigments added ratio:For white and fluorescent color 20%,other color 10%

3.Catalyst mixing ratio:2% slow dry XG-866B-1 and fast dry XG-866B-2 can mix together for using.

4.Thinner XG-128AH adding ratio:0-20% (for brush and pulling stone printing need 20-30%thinner)

5.Heating Temp and time: Flash cure temp :100℃- 120℃ for 6-12 seconds ,Drying temp :120℃- 140℃ for about 2 -5 minutes.

Printing Process

1.HD silicone under coating for two times

HD silicone XG-866AH/866A 300G

Fast dry catalyst XG-866B-2 6G 2%

Thinner XG-128AH 30G 10%

Heating temp 120-140degree

2.HD color effect printing for 2 times

HD silicone XG-866AH/866A 300G

Fast dry catalyst XG-866B-2 6G 2%

Color pigment 30G 10-20%(white and fluorescent color 20%)

Thinner XG-128AH 30G 10%

Flash temp 120-140degree

3.Pulling printing

HD silicone XG-866AH/866A 300G

Round silicone XG-866A-2Y 300G

Fast dry catalyst XG-866B-2 12G 2%

Color pigment 60G 10-20%(white&fluorescent color 20%)

Thinner XG-128AH 180G 30%

Heating temp 120-140degree for 2-3 minutesKey point for pulling pirnting

1.Silicone mix with 20-30% thinner

2.The angel between squeegee & table 60-70 degree,if manual printing about 45 degree

3.Keep distance between printing squeegee & screen

4.Less pressure print very soft and slowly

5.Move up screen slowly

Leave a Reply

您的电子邮箱地址不会被公开。 必填项已用*标注

我们将24小时内回复。
取消

Hi ,this is Kingjoe,May I have your name? Which type of silicone ink are you interested in?