How to print Elastic Webbing by golden glossy silicone effect?

Preparation:

  1. Mesh&Squeegee: 120(48T) Mesh number ;
  2. Squeegee 65-75 degrees Squeegee sharp and flat.
  3. Pigments added ratio: For white and fluorescent colors 20%, other colors 10%
  4. Catalyst mixing ratio:10%
  5. Silicone thinner XG-128AH adding ratio:10-20% :20%
  6. Heating Temp and time: Flash cure temp:100℃- 120℃ for 6-10 seconds, after finish printing to dry by temp:120℃- 140℃ for about 2 -3 minutes.

Elastic Silicone ink printing tips:

  • 1. Elastic Silicone ink for under coating and high density printing for 3-4 layers

Elastic silicone XG-130D-3 60 G

Elastic silicone catalyst XG-130DB 6 G 10%

Silicone thinner XG-128AH 6-12G 10%- 20%

Cure by temp of 120℃ for 6-10 seconds.

  • 2. Yellow color effect elastic silicone printing for 2 layers :

Elastic silicone XG-130D 60 G

Color pigment XG-203 6G 10-20%

 Elastic silicone catalyst XG-130DB 6 G 10%

 Silicone thinner XG-128AH 6-12G 10%- 20%

 Cure by temp of 120℃ for 6-10 seconds.

  • 3. Layers Golden powder silicone print 3 layers

 Elastic silicone XG-130D 60 G

Golden powders 6G 10%

Elastic silicone catalyst XG-130DB 6 G 10%

 Silicone thinner XG-128AH 6-12G 10%- 20%

 Cure by temp of 120℃ for 6-10 seconds.

  • 4. Glossy silicone ink top wet on wet printing 2 layers:

 Glossy silicone ink XG-399-2 60G

Slow dry catalyst XG-MB-1 6G 10%

Cure by temp of 80-100℃ for 10-25 seconds

It will be better to use low temp by longer heating time. To avoid bubbles problem. After printing finish, heat by 120℃- 140℃ for about 2 -3 minutes .

Gold silicone effect HD glossy gold silicone printing for taps

Leave a Reply

您的电子邮箱地址不会被公开。 必填项已用 * 标注

我们将24小时内回复。
取消

Hi ,this is Kingjoe,May I have your name? Which type of silicone ink are you interested in?