Preparation:
1.Mesh&Squeegee:120(48T)Mesh number;70-75 degree Squeegee.
2.Pigments added ratio:For white and fluorescent color 20%,other color 10%.
3.Catalyst mixing ratio:2%slow dry XG-866B-1 and fast dry XG-866B-2 can mix together for using.
4.Thinner XG-128A adding ratio:0-20%thinner is not necessary for hand printing
Heating Temp and time:Flash cure temp :100℃-120℃ for 6-12 seconds ,Drying temp:120℃-140℃ for about 2 -5 minutes
Printing process:
1.HD silicone XG-866AH for under coating 2 times.HD silicone ink with good fastness but semi
transparent.
HD silicone XG-866AH 50G
Thinner XG-128AH 5G
Catalyst XG-866B-2 1G
2.Round silicone XG-866LK-1 for clear high density printing for 2-5 times ,if need more highdensity then to print more times This round silicone is transparent but fastness not so good thatis why should print HD silicone first.Round silicone XG-866LK-150GThinner XG-128AH 10GCatalyst XG-866B-21G
3.Glossy silicone for top coating for 1 time If need supper glossy and smooth effect need thisstep.
Glossy silicone XG-399HR 50G
Catalyst XG-866B-21G
Key point for glossy printing
1).The angel between squeegee &table 60-70 degree,if manual printing about 45-75 degree
2).Keep distance between printing squeegee &screen
3).Less pressure print very soft and slowly try to get more ink pass through the mesh to getround glossy effect.
