Preparation:
1.Mesh&Squeegee: 100-120(40-48T) Mesh number ;65-75 degree Squeegee.
2.: Pigments added ratio:For white and fluorescent color 20%,other color 10%
3.Catalyst mixing ratio:2% slow dry XG-866B-1 and fast dry XG-866B-2 can mix together for using.If
machine printing to chose slow dry catalyst or slow and fast dry half and half.
4.Silicone thinner XG-128A adding ratio:0-20%
5.Heating Temp and time: Flash cure temp :100℃- 120℃ for 6-10 seconds ,Drying temp :120℃- 140℃
for about 2 -3 minutes.
Printing process:
1. Soft silicone for under coating and high density printing for 2-8 times :
Soft silicone XG-866AR+ 60G Or use HD silicone XG-866AH
Fast dry catalyst XG-866B-2 1.2G 2%
Silicone thinner XG-128AH Silicone thinner is not necessary
Flash by temp of 120℃ 6- 10 seconds.
If fabric with serious hairy or want to get more smooth effect kindly assist by heat press machine or iron on the third time printing,after third time printing keep wet to heat press by temp 150-170 degree for
10-20 seconds.
2. Color effect silicone printing for 3-4 times :
Soft silicone XG-866AR+ 50G Or use HD silicone XG-866AH
White color pigment XG-102 10G For white and fluorescent color 20%,other color 10%
Fast dry catalyst XG-866B-2 1G 2%
